Table of Contents
Advertisement
Location and Function of Parts and Operation
Front/top/bottom
a Lens mount (C-mount)
Attach any C-mount lens or other optical equipment.
Note
Use a C-mount lens where the protrusion (a) extending
from the lens mount face (b) is 10 mm (13/32 inch) or
less.
When attaching a lens to the camera, note that the
resolution of the image that is output from the camera
may vary depending on the performance of the lens.
The performance of the same lens may also vary
depending on the aperture value.
If the resolution is insufficient, adjust the aperture value.
b Camera mount guide screw holes (top)
c Camera mount guide screw holes/Tripod
attachment screw holes (bottom)
When using a tripod, use these four screw holes to attach
a VCT-333I Tripod Adaptor.
For details, see "Mounting on a tripod" (page 7).
d Camera mount reference screw holes (bottom)
These precision screw holes are for securing the camera
module. Securing the unit with these holes minimizes
any optical axis alignment offset.
For details about the size of and position of guide holes
and reference holes, see "Dimensions" (page 44).
a
b
5
Rear
e
(DC power input) connector (6-pin)
You can connect a camera cable to input a 12 V DC
power supply. The pin configuration of this connector is
as follows.
(Refer to part e above for the pin assignment of the
connector.)
Pin No.
Signal
1
DC input
(10.5 V to 15 V)
2
GPI1 (ISO +)
3
GPI2/GPO2
f USB connector (Micro B type)
Connect a USB 3.0 cable to control the camera module
from a host device and to send image signals from the
camera module. Power can be supplied from a USB 3.0
interface video input board or from a USB hub over the
USB 3.0 cable.
CAUTION
• For safety, do not connect the connector for peripheral
device wiring that might have excessive voltage to this
port. Follow the instructions for this port.
• Use a Standard USB A to USB Micro B, USB 3.0
cable that is compatible with the USB3 Vision
standard.
• USB 2.0 is not supported.
g Status LED (green)
Displays the unit status.
For details, see "Status LED" (page 30).
Pin No.
Signal
4
GPO3 (ISO +)
5
ISO –
6
GND
Advertisement
Table of Contents
