Parameter Window X: Control Dynamics - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
3.2.12 Parameter window
X: Control Dynamics
© 2008 ABB STOTZ-KONTAKT GmbH
Commissioning
The parameter window X: Control Dynamics is enabled if in parameter
window the parameter Changing brightness during lighting control
X: Control
with the option individual setting has been selected.
The control dynamics influence the behaviour of the control function.
Generally this fine tuning of the control circuit is not necessary.
Normally the artificial lighting and daylight calibration with the preset control
dynamic parameters is sufficient to set good and stable constant lighting
control. If however this is not the case and it is not possible to set stable
lighting control due to special conditions in the room, e.g. delays in the
lighting circuit, manual fine tuning of the lighting control can be undertaken
with these enabled control dynamic parameters.
Max. time between two control steps
Options: as fast as possible
0.1/0.2...1
* Default value if control parameterised as a master
This parameter defines the step time of a control step in the start up phase.
The smaller the step time, the faster that the control steps are applied with
their increment size (brightness). The Light Control quickly approaches the
setpoint.
*
...9/2.0 s
69