Per Output For Function Slave Mode - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
3.3.7 Per output for function
Slave mode
© 2008 ABB STOTZ-KONTAKT GmbH
Commissioning
No. Function
24, 49,
Activate slave mode
1
74, 99
This object is enabled if in the parameter window
mode in lighting control has been enabled and simultaneously in parameter window
the parameter Slave is controlled via with the option External via object is set.
The object serves for activation / deactivation of the slave mode. With deactivation
the device behaves like a "normal" Light Controller without slave function. The slave mode
can be reactivated if a telegram with the value 1 is received via this object.
By setting the T flag the object is actively sent after bus voltage recovery.
Telegram value: 0 = slave mode not activated
1 = activate slave mode
25, 50,
Brightness value of slave
1
75, 100
This object is enabled if in parameter window
in lighting control is enabled.
The slave output receives the brightness value via this object, e.g. from a higher level
Light Controller which is parameterised as the master.
If the mode is deactivated or slave mode is latent, after an Off command 0 to the object
Switch or Switch / Status, the telegrams to the object Slave brightness value have no effect.
In the parameter window
X: Slave
command interrupts the slave mode.
Brightness values which are above or below the predefined max. or min. brightness values
are not set. In this case the value limits are set.
Telegram value: 0
...
255 = 100 %
1)
The numbers of the objects apply for outputs A to D.
Object name
Output X
X: General
Output X
the additional function Slave mode
X: General
you can parameterise if a dim, set value, scene or preset
= OFF output is switched off, slave mode remains
Active.
Data type Flags
1 bit (EIS1)
C, W
DPT 1.003
the additional function Slave
X: Slave
1 byte (EIS6)
C, W, T
DPT 5.001
96