ABB i-bus KNX Product Manual page 84

®
ABB i-bus KNX
© 2008 ABB STOTZ-KONTAKT GmbH
Commissioning
Reaction on switching off via
object "switch"
Options: no reaction
switch on basis brightness
dimming on basis brightness
switch off
•
no reaction: Switch off telegrams are ignored.
•
switch on basis brightness: The lighting switches to basis brightness as
has been parameterised in the parameter After staircase time dimming
to base brightness.
•
dimming on basis brightness: With switched on lighting the dimming
phase is started with the corresponding dimming time and basis
brightness.
•
switch off: The lighting is switched off.
If Permanent ON is active the switch OFF telegram is ignored and not
processed.
Brightness value during permanent ON
Options: 100/99...1/0 % (OFF)
This parameter is used to set the brightness of the lighting which is to
be retained during the Permanent ON phase (object Permanent ON
the value 1).
Note
Forced operation and blocking have a higher priority!
Restart of staircase time after
end of permanent ON
Options: no (dim down immediately)
yes
•
no (dim down immediately): The lighting switches off if Permanent ON is
ended.
•
yes: The lighting remains on and the staircase lighting time restarts.
Warning during dimming down
(object "Warning stairc. lighting")
During the dimming time additional warning is possible by setting the object
Warning staircase lighting to 1. Thus for example, a pushbutton LED can be
controlled or a warn signal initiated which informs concerning the impending
staircase lighting switch off.
82