Sensor Setup; Add The Sensor To The Controller - Toro Precision Soil Sensor Manual

Sensor Setup

Implement the following two procedures to successfully setup
Toro's Precision™ Soil Sensor:
1. "Add" the sensor to the controller for successful wireless
communication.
2. Calibrate the sensor for proper irrigation operation.

1. Add the Sensor to the Controller

Every soil sensor has a unique
ID number. That number must
be "added" to the controller.
ADVANCED
1. Press
then .
to ADD/REMOVE
2.
DEVICE.
to confirm.
ADVANCED
ZONE DETAILS
SCHEDULE STARTS
SCHEDULE DETAILS
SENSORS
ADD/REMOVE DEVICE
to SOIL 1.
3.
ADD/REMOVE DEVICE
WS
SOIL 1
SOIL 2
SOIL 3
AUX 2
4. The EVOLUTION® controller waits for the identification
signal from the soil sensor.
ADD/REMOVE DEVICE
INSTALL BATTERY OR
WAIT FOR SIGNAL
MAY TAKE 30 MINUTES
• If the soil sensor has had batteries installed in the last 30
minutes, the controller should detect and add the sensor
immediately.
• If the sensor is out in the field, it could take up to a half
an hour to detect and add the sensor.
• One can remove and reinstall the soil sensor's batteries to
achieve immediate sensor detection.
to ADD.
to confirm.
ADD
ADD
ADD
ADD
ADD
ADD
CANCEL
5