Installing The Fuse; Calibrating The Sensor - Toro 02951 Installation Instructions Manual

3

Installing the Fuse

Parts needed for this procedure:
1 Fuse (2 A)
Procedure
1. Open the lid on the left pod.
2. Remove the 3 knobs inside the storage pod
(Figure 3).
1. Knobs
3. Remove the storage pod and locate the fuse
block.
4. Remove the fuse-block cover and install the
fuse in the location shown in
Figure 3
2. Front knob
Figure 4.
1. Install the fuse in this
location
5. Install the fuse-block cover and install the
storage pod with the 3 knobs.
4

Calibrating the Sensor

g338478
No Parts Required
Procedure
Note:
When you first turn the ignition key to on, the
InfoCenter shows advisory B2710, Calibrate Slope
Sensor.
1. While on a flat surface, remove the plug from
the calibration connectors
2. Plug the calibration connectors together as
shown in
4
Figure 4
2. Fuse block
(Figure
Figure 5.
g338477
5).