Page 1
Form No. 3440-871 Rev A Slope Sensor Kit LT3340 Triple Reel Mower or LT-F3000 Triple Flail Mower Model No. 02951 Installation Instructions Note: This kit is for Stage 5 machines only. Safety Safety and Instructional Decals Safety decals and instructions are...
Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the machine. Slope sensor Carriage bolt (1/4 x 2 inches) Lock nut (1/4 inch) Install the kit. Spacer Slope sensor decal Fuse (2 A)
Page 3
g308336 Figure 2 1. Machine-stability decal 2. Slope-sensor decal g338090 Figure 1 1. Carriage bolt (1/4 x 2 4. Slope snsor inches) 2. Machine frame 5. Lock nut (1/4 inch) 3. Spacer Locate the slope sensor connector in the main wire harness and plug it into the slope sensor.
Installing the Fuse Parts needed for this procedure: Fuse (2 A) Procedure Open the lid on the left pod. Remove the 3 knobs inside the storage pod (Figure g338477 Figure 4 1. Install the fuse in this 2. Fuse block location Install the fuse-block cover and install the storage pod with the 3 knobs.
Page 5
g317524 Figure 6 1. LED light When the InfoCenter shows Message 601, Slope Sensor Calibrated, Cycle keyswitch, and the light no longer blinks, turn the ignition key to the O position. Disconnect the calibration connectors and install the plug onto the connectors. g350905 Figure 5 1.
Operation Using the Slope Sensor The light and alarm indicates the severity of the slope: • Red light—normal operating conditions • Slow, flashing red light and Advisory B2713 displaying on the screen—moderate slope g317557 Figure 8 Advisory B2713 • Fast, flashing red light, audible alarm, and Advisory B2714 displaying on the screen—steep slope;...