Table of Contents
Advertisement
Figure 5
1. Calibration connectors
3.
Turn the ignition key to the O
not start the engine.
4.
The InfoCenter shows Message 600, Slope
Sensor Calibrating.
Note:
The LED light at the top of the display
screen blinks as the sensor calibrates.
g350905
2. Plug
position, but do
N
1. LED light
5.
When the InfoCenter shows Message 601,
Slope Sensor Calibrated, Cycle keyswitch, and
the light no longer blinks, turn the ignition key to
the O
position.
FF
6.
Disconnect the calibration connectors and install
the plug onto the connectors.
1. Calibration connectors
7.
Install the plastic cover.
8.
Lower the seat platform and ensure it is latched.
5
Figure 6
Figure 7
2. Plug
g317524
g315597
Advertisement
Table of Contents
