Racking Handle; Manual Opening Handle - ABB AMVAC Installation And Operation Manual

R H
ACKING ANDLE
The racking handle is designed to easily adjust the
device into and out of a switchgear enclosure. It is
also used to change the position of the device from
the Disconnect, Test, and Connect positions. Press
down on the release lever (1) and rotate racking
handle (2) clockwise to rack in (toward Connect) and
counter clockwise to rack out (from Connect).
Use of any other racking device not approved by ABB will void the warranty!!
ABB will not be responsible for damage caused by the use of racking tools other than ABB's.
M T H
ANUAL RIP ANDLE
The manual opening handle (1) is designed to
open the AMVAC circuit breaker manually. Insert
the handle into the opening in the front panel (2)
and turn it counter-clockwise until the circuit break-
er opens. The manual opening handle shall be
stored in close proximity to the circuit breaker
switchgear for easy access.
(1)
Manual Trip Handle
8
ACCESSORIES
:

Racking Handle

:
2
1VAL050601-MB Rev C
1
2
CAUTION
1