Mitsubishi Electric GT15-J61BT13 User Manual page 17

Single
1 station
occupied
RYn0
RYn0 to RYnF
to RY(n+6)F
RY(n+1)0 RY(n+7)0
to RY(n+1)F to RY(n+7)F
Quadruple
1 station
occupied
RYn0 RYn0
to RY(n+2)F to RY(n+1A)F
RY(n+3)0 RY(n+1B)0
to RY(n+3)F to RY(n+1B)F
*1 When the mode setting of CC-Link is Ver.1, the extension cyclic
setting is not available. (Fixed to Single)
*2 The remote READY flag is on during startup of the GOT.
It switches on when GOT power is switched on, hardware reset is
made, or the GOT is ready to operate.
If GOT power is on, the remote READY flag is off when offline
operation is performed (during OS installation or screen data
downloading) or while initial processing is executed.
Use it for the interlock ladder when writing or reading data to or from
the CC-Link Master station.
Signal Direction : GOT
Device No.
Extension cyclic setting*
4 station 1 station
occupied occupied
RYn0
to RYnF
RY(n+1)0
to RY(n+1)F
Signal Direction : GOT
Device No.
Extension cyclic setting*
4 station 1 station
occupied occupied
RYn0
to RY(n+6)F
RY(n+7)0
to RY(n+7)F
Master module
1
Double
4 station
occupied
RYn0
to RY(n+C)F
RY(n+D)0
to RY(n+D)F
Master module
1
Octuple
4 station
occupied
RYn0
to RY(n+36)F
RY(n+37)0
to RY(n+37)F
6
Signal name
User area
Reserved
Signal name
User area
Reserved