Panasonic HL-BD82S Service Manual page 28

HL-BD82S
6. Assemble the glass and door keeping door in the middle
of the glass and making attention at correct position of
rubber bumpers.
7. Replace the Oven door following the (section 5.10.Oven
Door Removal).
7.20. Door internal glass replace-
ment
1. Remove the door from the oven (see section 5.10.Oven
Door Removal).
2. Put the door on a flat surface with a soft cloth to prevent
scratching of the aesthetics.
3. Remove the external glass from the door unscrewing two
screws on the corner and three screws on the bottom
(see section 7.19.Door external glass replacement).
4. Remove the four screws with its spacers which fix the
main screen glass A.
5. Remove the metal frame B to reach the two internal glass
C separated by a square metal spacer D.
6. Now depends which glasses is broken, replace with the
new one.
7. When it is changed an internal glass you must be
sure that the face whit CA (CAVITY) printed it is
towards the cavity.
8. Assemble the glass and door keeping door in the middle
of the glass.
9. Replace the Oven door following the (section 5.10.Oven
Door Removal) .
7.21. Lampholder replacement
1. Disconnect the power supply cord and remove the Oven
from the cabinet.
2. Remove the lampholder cover panels situated on the side
of the oven and unscrew the relative ground wire A
3. Remove the lampholder removing its screw and extract
the defective lampholder from the oven cavity. Cut the
defective lampholder wires just above the lampholder
body. Mount the new lampholder in the oven cavity and fix
with the relative fixing screw.
4. Twist together the new lampholder wires to the old defec-
tive lamp holder wires then 'run' them through the relative
protective sleeve. Once the new lampholder wires come
through the other end of the protective sleeve untwist the
wires and dispose of the old wiring as follows.
5. Using a sharp tipped screwdriver carefully unlock the old
wiring 'faston' type connector spade terminal. Once the
old wires are released you can through them away.
Retain the old lampholder connector for the new lam-
pholder as this will be recovered for further use (see next
point).
6. Take the new lampholder and insert the wires into the
recovered connector. This is done by pushing each 'fas-
ton' wiring spade terminal into the connector until it 'clicks'
in place. Ensure that both new lampholder wires are
firmly in place before reassembling the lamp connector.
Ensure that the male and female parts of the connector
are firmly locked together.
28