Connecting The Optional Slice Vesa Plate - HP Elite Slice for Meeting Rooms G2 Hardware Reference Manual

6. Align the module connection port on the underside of the Elite Slice G2 with the module expansion
connector on the new module and press the computer down firmly.
You should hear a quiet click when the modules lock together. The module locks into place and hides the
release latch of the module above it.
Repeat until all modules have been connected.

Connecting the optional Slice VESA Plate

If the VESA Plate is connected, the Elite Slice G2 can be mounted onto a table.
CAUTION:
source.
1. Slide the quick release latch on the VESA Plate to the unlocked position. Position the connected modules
over the VESA Plate.
The VESA Plate does not have a module expansion connector. Be sure that the ports of the Elite Slice G2
and the quick release latch and security cable slot of the VESA Plate are all on the same side.
2. Press the modules down onto the VESA Plate.
8 Chapter 2 Setup
Before connecting the VESA Plate, turn off the Elite Slice G2 and disconnect it from any AC power