HP Elite Slice for Meeting Rooms G2 Hardware Reference Manual page 25

1. Connect the desired modules to the Elite Slice G2.
2. Place the Elite Slice G2 in a central location.
Be sure nothing is placed on top of or next to the Elite Slice G2 that could block speakers and
microphones.
3. Connect the Cable and Port Cover to the Elite Slice G2:
a. Pull the port cover down (1) to expose the cable connectors.
b. Pull the first and last connectors out to each side (2).
c. Beginning with the HDMI connector and finishing with the NIC connector, plug all middle connectors
into the rear ports (3) on the Elite Slice G2.
d. Connect the first and last connectors (4).
e. Push the port cover back over the cable connectors (5) to protect and secure the connectors.
4. If the Wireless Display Module is installed, perform the following steps:
a. Connect a display power cord to an AC outlet (1).
b. Secure the wireless receiver transceiver to the back of the display (2) with the included adhesive
strip.
Setting up an Elite Slice G2 conferencing solution 19