3.2
SIP Trunk Programming Guide
CC-CP00 Network Setup
Values shown are for example purposes only. Your actual IP values will be
determined by your local LAN administrator.
Figure 3 CM 0B1xx Network Setup
1.
Select SV9300 Main/Remote Unit No. accommodating SIP Trunk
Channels, then click Read to get the current data settings.
2.
FD=00 Enter SV9300 VoIPDB IP Address.
FD=01 Enter SV9300 VoIPDB Subnet Mask.
FD=02 Enter SV9300 VoIPDB Default Gateway Address.
3.
FD=10 Set VoIPDB location number.
4.
FD=36 Leave Blank to use default port 5060 for SIP trunk control
packets. Change this only at the request of Spectrum Enterprise. It was
requested to change for test environment.
Issue 1.0
7