Route To Route Connection Settings - NEC Univerge SV9300 Programming Manual

Issue 1.0
3.7
18

Route to Route Connection Settings

All values shown are for example purposes only. Your actual values will be
determined by your implementation team.
Figure 13 CM 36 Route to Route Connection Settings
1. Select Incoming Trunk Route.
2. Select Outgoing Trunk Route and click the Read button to get current
data settings.
3. Select 0 to allow route to route connection.
Allow route to route connection (i.e. SIP route to PRI route, PRI route to SIP

route, and SIP route to SIP route).
4. Click Apply.
Command Line Example:
CM 360>0101>0
Spectrum Enterprise
(Route to Route Connection)
SIP Trunk Programming Guide