Preparing The Module - Siemens SIMATIC S5 Manual

Planning
7.1.5.2

Preparing the Module

Set the signal level required by your power unit on the module.
5 V differential inputs
or optocoupler input
24 V optocoupler input
5 V -24 V optocoupler inputs
(Special voltages)
Set the module for the required BASP response.
There is no CPU in operation or the module should not react to the BASPsignal
If the BASP signal is received, the signal output must be blocked
Set the addresses.
If the module is to be controlled by the CPU, you must set the appropriate page address
(in whole multiples of four, e.g. 0,4, 8,,,252). These page addresses must only be
assigned once in the programmable controller.
Address set at switch S2 on the module,
Page address
The address selected and the three following addresses are not used for any other
purpose,
7 - 1 0
Connector X30 Jumper 2-4 inserted
Connector X31 Jumper 2-3 inserted
Connector X30 Jumper 3-4 inserted
Connector X31 Jumper 1-2 inserted
Connector X30 Jumper 4-6 inserted
Connector X31 Jumper 1-2 inserted
Connector X21 Jumper 1-2 inserted
Connector X21 Jumper 2-3 inserted
I