Installation
Installation
3.2.1
Inserting and Removing the Module
The module can only be plugged into the slots interided for CPS in the PC or EU. The module
may only be removed when the programmable controller or the expansion unit is switched
off.
3.2.2
Connecting the Signai Lines
The signal lines are connected via the connectors on the front panel, The braided shield is con-
nected to the metallized part of the connector cover.
Connecting cables to the power units should be laid with shield clamps at the device reference
potential, as recommended in the Installation Instructions C79000-B8576-C452, Section 7.7.
Note
With the exception of the PG interface, the insertion and removal of the front
connectors during operation of the module is not permitted.
3 - 8