Advertisement
Document No. 563-067
Installation Instructions
February 23, 2011
5.
Connect the antenna. Be sure the antenna is
securely connected to the RSX.
For a remote mount antenna, do the following:
a. Locate the liquid tight fitting so the
antenna extension cable does not incur
excessive pull force. At the enclosure,
punch a 1/2 in. (1.3 cm) knockout and
use the locknut to secure the body of
the liquid tight fitting into the knockout.
b. Route the antenna through the body of
the liquid tight fitting (Figure 5). Hand-
tighten the liquid tight fitting nut to
secure the antenna in place.
Make certain the liquid tight fitting nut
tightens on the antenna base, not the
antenna itself, so the antenna can be
adjusted.
c. Connect the antenna wire securely to the
RSX.
6.
Position the antenna in a vertical orientation (up
or down).
7. Install and bind associated Wireless Room
Sensor (WRS) to the RSX.
•
If the associated WRS is new or is shipped
with the RSX, install WRS per the Wireless
Room Sensor (WRS) Installation Procedure
(563-065).
•
If the associated WRS is already installed,
bind the RSX and WRS per the Wireless
Room Sensor Solution User Guide
(563-068).
The RSX installation is complete.
Page 4 of 5
Antenna Cable 12 inches
(305 millimeters)
Liquid Tight Fitting
Installed in
Enclosure Knockout
Liquid Tight Fitting
Threaded Body
Liquid Tight
Fitting Nut
Antenna
Base
Antenna
Liquid Tight Fitting Locknut
Figure 5. Remote Mount Antenna.
Table 1. RSX-to-TEC Cable Pin Connections.
Connector A
(RJ-11)
Pin 1
Pin 2
Pin 3
Pin 4
Pin 5
Pin 6
Connector B
(RJ-11)
Pin 1
Pin 2
Pin 3
Pin 4
Pin 6
Pin 5
Siemens Industry, Inc.
Advertisement
