Using The Cmc Cli To Set The Ip Address - Dell FC SAN User Manual

For LINUX or UNIX
Task 2: Changing the IP address
1. Verify that the FC SAN Module has completed POST. When POST is complete, the port status
2. Enter the CLI ipAddrSet command.
3. Enter ipAddrShow at the prompt to verify that the address was correctly set.

Using the CMC CLI to set the IP address

Use the following steps to connect modify the FC SAN Module IP address through the CMC CLI.
1. Establish a Telnet session to the CMC CLI.
Dell 8/4Gbps FC SAN Module Hardware User's Manual
53-1001964-01
e. From the COM Port Properties window, select the following configuration values:
•
Bits per second: 9600
•
Databits: 8
•
Parity: None
•
Stop bits: 1
•
Flow Control: None
a. Enter the following at the command prompt:
tip /dev/ttyb -9600
b. When the terminal application stops reporting information, press Enter to display the login
prompt.
c. Log in to the default administrative account using the following identification:
Login: admin
Password: password
d. When prompted either change the administrative password, or press Ctrl-C to bypass.
and FC SAN Module power and status LEDs return to a standard healthy state.
Follow on-screen instructions and supply the correct information, as shown in the following
example.
switch:admin> ipaddrset
Ethernet IP Address [10.77.77.77]:10.32.53.47
Ethernet Subnetmask [255.255.255.0]:255.255.240.0
Fibre Channel IP Addresss [none]:
Fibre Channel Subnetmask [none]:
Gateway IP Address [0.0.0.0]:10.32.48.1
DHCP [Off]:
IP address is being changed...Done.
Modify the FC SAN Module IP address
2
15