Silvercrest SWK 360 A1 Operating Instructions And Safety Instructions page 47

NOTE
► Alternatively, you can use the double-sided tape
Before assembly, remove the strap from the arm mount
sure that you apply it to a clean, fat-free and dry surface.
► Once you remove the double-sided tape
Suction cup mount
You will need the following accessories to install the suction cup mount
♦ Undo the screw cap on the suction cup mount
♦ Push the ball joint on the ball adapter
♦ Re-tighten the screw cap on the suction cup mount
♦ Place the thread
tight.
NOTE
► Before continuing, read the section Basic safety instructions.
♦ Push the suction cup firmly onto a window, e.g. the windscreen, and press the locking lever
towards the glass pane. This creates a vacuum and the suction cup is pulled tightly against the
glass. Raise the lever to remove the suction cup from the glass. The suction cup has a tab at the
side, which makes it easier to remove.
SWK 360 A1
+
into the screw cap on the suction cup mount
on the camera onto the fixture of the ball adapter
to mount the arm mount
. When mounting the device, make
after assembly, it cannot be reused.
+
.
.
on an object.
:
.
and screw the camera
GB│IE│NI 43
│
■