Inserting/Replacing The Battery In The Remote Control - Silvercrest SWK 360 A1 Operating Instructions And Safety Instructions

CAUTION
► Refit the side compartment cover
is essential for when the camera comes into contact with water (see section Removing/at-
taching the side compartment cover).

Inserting/replacing the battery in the remote control

NOTE
► Before continuing, read the section Notes on batteries and rechargeable batteries.
To insert the supplied CR2032 button cell battery
proceed as follows:
♦ Open the battery compartment
and pulling it out with a fingernail (see figure 09).
♦ Remove the old battery.
♦ Insert a CR2032 battery into the battery compartment
upwards (see figure 10).
♦ Push the battery compartment
figure 10).
Fig. 09
SWK 360 A1
after the memory card has been inserted/removed. This
or to change a battery of the same type,
by pushing the catch towards the battery compartment
back into the remote control
Fig. 10
. The positive terminal should face
until it locks into place (see
GB│IE│NI 17 ■
│