Hitachi Compute Rack CR 210H User Manual page 53

Setup method in Windows Server 2008 R2
1. Double-click Control Panel > Device Manager.
2. Open the Details tab page of the properties windows of each network
adapter in Network adapters.
3. Change the settings according to the following table if the setup items are
displayed:
Table 4-1: Settings of network adapter properties
IPv4 Checksum Offload
TCP/UDP Checksum Offload
(lpv4)
TCP/UDP Checksum Offload
(lpv6)
Large Send Offload (IPv4)
Large Send Offload v2(IPv4)
Large Send Offload v2(IPv6)
Receive Side Scaling
4. After setting all items, click OK and restart the OS.
Item
Broadcom Advanced
Rx & Tx Enabled → None
Rx & Tx Enabled → None
Rx & Tx Enabled → None
Enable → Disable
Enable → Disable
Enable → Disable
Enable → Disable
Operational precautions
Hitachi Compute Rack 210H Series User's Guide
settings
Control Suite 4
not installed
Broadcom Advanced
Control Suite 4
installed
Rx & Tx Enabled → None
Rx & Tx Enabled → None
Rx & Tx Enabled → None
Enable → Disable
Enable → Disable
Enable → Disable
Enable → Disable
4-3