Bosch WKD28350GB Repair Instructions page 18

Fault
"Drain/Spin" or "Drain" programme
is not run
"Rinse/Spin" programme is not run
Drying programme is run without
warm spin cycle
Drying time too long
815_58300000146136_ara_en_b.doc – 12.04.10
Cause
Water temperature NTC > 60 °C
(N1)
Air temperature "NTCD1" > 68 °C
(N0)
Water temperature NTC > 60 °C
(N1)
Air temperature "NTCD1" > 68 °C
(N0)
NTC washing solution tub (NTCD1)
defective
NTCD1 or NTCD2 defective. No
error on the display, extended
drying time.
Fault correction
Before draining, a cool down is run
until the water temperature < 60 °C
is reached (max. filling time 3').
If T < 60 °C is not reached within
3 min., only the drain cycle is run.
Before draining, a cool down is run
until the air temperature NTCD1 <
60 °C is reached (max. filling time
10'). If NTCD1 < 60 °C is not
reached within 10', only the drain
cycle is run.
Before the programme starts,
"cool down" is run until the water
temperature < 60 °C is reached
(max. filling time 3').
Before the programme starts, a
cool down is run until the air
temperature NTCD1 < 60 °C is
reached (max. filling time 10').
Check NTC washing solution tub
(NTCD1), if required replace.
Check NTCD1 and NTCD2 and,
if required, replace.
Advise customer
This may occur if the user stops the
wash programme and selects
"Drain/Spin" or "Drain"
This may occur if the user stops
the drying programme and selects
"Drain/Spin" or "Drain"
This may occur if the user stops
the wash programme and selects
"Rinse/Spin"
This may occur if the user stops
the drying programme and selects
"Rinse/Spin"
Seite 18 von 32