Software Update; How To Proceed If A Repair Is Necessary - Siemens SITRANS LG270 Operating Instructions Manual

PBD-51041071
•
In the factory
•
Or on site by the user
In both cases, the serial number of the sensor is needed. The serial
numbers are stated on the type label of the instrument, on the inside
of the housing as well as on the delivery note.
When loading on site, the order data must first be downloaded from
the Internet (see operating instructions manual "Electronics module").
Caution:
All application-specific settings must be entered again. That's why you
have to carry out a fresh setup after exchanging the electronics.
If you saved the parameter settings during the first setup of the sen-
sor, you can transfer them to the replacement electronics module. A
fresh setup is then not necessary.
9.6

Software update

The following components are required to update the sensor soft-
ware:
•
Sensor
•
Voltage supply
•
PC with PACTware
•
Current sensor software as file
You can find the actual sensor software as well as detailed infor-
mation of the procedure in the download area on our homepage:
www.siemens.com/sitranslg.
You can find information about the installation in the download file.
Caution:
Instruments with approvals can be bound to certain software versions.
Therefore make sure that the approval is still effective after a software
update is carried out.
You can find detailed information in the download area on our home-
page: www.siemens.com/sitranslg.
9.7

How to proceed if a repair is necessary

If it is necessary to repair the instrument, please contact Sie-
mens Milltronics Process Instruments. You find the locations on
"www.siemens.com/sitranslg".
SITRANS LG270 - Operating Instructions
55