Software Update - Siemens SITRANS LG260 Operating Instructions Manual

PBD-51041057
7. Cable: Fasten the cable with three pins, torque 20 Nm
(14.75 lbf in)
Cable ø 4: 7 Nm (5.16 lbf ft)
Cable ø 6, cable ø 8: 20 Nm (14.75 lbf ft)
8. Enter new probe length and then carry out a fresh adjustment
(see "Setup procedure, Carrying out min. adjustment - Carrying
out max. adjustment").
A
Fig. 39: Shortening the cable probe
A Gravity weight - cable ø 4 mm
B Gravity weight - cable ø 6 mm
1 Threaded pins
2 Thread M12 for eye-bolt
3 Threaded pins
9.7

Software update

The following components are required to update the sensor soft-
ware:
•
Sensor
•
Voltage supply
•
HART modem
•
PC with PACTware
•
Current sensor software as file
You can find the actual sensor software as well as detailed infor-
mation of the procedure in the download area on our homepage:
www.siemens.com/sitranslg.
You can find information about the installation in the download file.
Caution:
Instruments with approvals can be bound to certain software versions.
Therefore make sure that the approval is still effective after a software
update is carried out.
SITRANS LG260 - Operating Instructions
1
2
3
B
2
61