Siemens SITRANS LG260 Operating Instructions Manual page 42

Menu item
Date
Time
Time - Format
Probe type
Additional adjustments -
Copy instrument settings
Additional settings - Scal-
ing level
Additional settings - Scal-
ing level 1
42
Default value
Actual date
Actual time
24 hours
Device-specific
The instrument settings are copied with this function. The following
functions are available:
•
Read from sensor: Read data from sensor and save in the display
and adjustment module
•
Write to sensor: Save data from the display and adjustment mod-
ule back into the sensor
The following data or settings for adjustment of the display and ad-
justment module are saved:
•
All data of the menu "Setup" and "Display"
•
In the menu "Additional adjustments" the items "Reset, Date/Time"
•
Special parameters
The copied data are permanently saved in an EEPROM memory in
the display and adjustment module and remain there even in case of
power failure. From there, they can be written into one or more sen-
sors or kept as backup for a possible electronics exchange.
Note:
Before the data are stored in the sensor, a check is carried out to
determine if the data fit the sensor. If the data do not fit, a fault signal
is triggered or the function is blocked. When data are being written
into the sensor, the display shows which instrument type the data
originate from and which TAG-no. this sensor had.
Since scaling is very extensive, scaling of the level value was divided
into two menu items.
In menu item "Level 1" you define the scaling variable and the scaling
unit for the level value on the display, e.g. volume in l.
SITRANS LG260 - Operating Instructions
Modified value
PBD-51041057