Advertisement
For Ventilation
For correct ventilation, the ventilation opening of 50mm should be required between the
back wall and the floor of the installation cabinet (See "Q " fig--1D, 2B & 3A), the ventilation gap
of 5mm is required between the oven top rim and the cooktop lower rim, and between the oven
both sides rim and the cabinet (fig-3B, 3C), these openings must not be closed by any way. So
ensure that the sides are not touching the front edges of the housing.
Connect the oven to the power supply. Secure the oven to the kitchen unit with screws (Fig-3D).
Conneting the oven to the power supply
The oven must be connected by a licensed specialist in accordance with this instructions and in
compliance with local regulations. Make sure the voltage shown on the rating plate is the same
as the power supply voltage in your home.
Use a type H05 VV-F power cord. The oven must be connected to the power supply by means of
an all-pole disconnect switch with a minimum contact gap of 3mm and must be connected to
earthed socket by law. The supply plug shall be accessible after the installation.
The oven's componets operate at 220-240V. Identify the phase and neutral conductor in the
socket. Incorrect connection may damage the oven (Fig-3E).
min. 50
[fig-3A]
[fig-3D]
oven
min. 5
close kitchen cabinet
[fig-3B]
3
min.5
or appliance.
[fig-3C]
Live
Neutral
[fig-3E]
Earth
Advertisement
