Trimming The Bikini Line With The Precision Trimmer And Trimming Comb - Silvercrest SBT 3.6 A1 Operating Instructions Manual

NOTE
► It is possible that some hairs will grow back after a few days. The reason for this
is that these hairs were too short to be removed during the last epilation session.
6) When you are fi nished with the treatment, push the on/off switch w in the opposite
direction to switch off the appliance.
7) Clean the epilator head 1 as described in the section "Cleaning and Care".
NOTE
If the epilator head 1 is damaged, do not use it any more! To order a new epilator
►
head 1, please contact the service department (see chapter "Guarantee and
service"). Please have the IAM number ready (see operating manual cover).
Trimming the bikini line with the precision trimmer and
trimming comb
Use the precision trimmer 6 with the precision comb 8 to trim your bikini line.
1) Start by removing any other attachment from the hand element q, if required.
Fit the precision trimmer attachment 6 onto the hand element q so that the two
grooves in the attachment match up with those on the back of the hand element q.
2) Push the precision comb 8 with its side rails onto the two grooves on the appliance
until it clicks into place.
3) You can vary the cutting length to any one of the fi ve settings. To do this, press on
the grooved area 9 on the precision comb 8 so that the locking catch 0 is pushed
into the housing. Then push the precision comb 8 to the cutting length position that
corresponds to the desired length. Use the cutting settings on the precision comb 8
as an orientation aid as well as the following table:
Setting
1
2
3
4
5
4) Push the on/off switch w in the direction of the attachment.
5) Hold the skin tight with one hand.
6) Place the appliance perpendicular to the skin and, without exerting any pressure, move
it against the direction of the hair growth. The fl at side of the precision comb 8 must
always be set against the skin to achieve an even cut.
SBT 3.6 A1
Hair length after cutting
approx. 3 mm
approx. 5 mm
approx. 7 mm
approx. 9 mm
approx. 11 mm
GB
CY
9