Panasonic CM602-L Reference Manual page 26

1.4 Other Specifications
2. When wishing to use the nozzles for CM401/CM402/CM602 on the former models,
you need to detach CM401/CM402/CM602-specific orifices from them (for using
some nozzles) or change the settings of a vacuum sensor (for using all nozzles).
In this case, one of the following two setup (handling) procedures is required. See below.
a. Detaching CM401/CM402/CM602-specific orifices (when using some nozzles)
CM401/CM402/CM602-ready nozzle
CM401/CM402/CM602-ready nozzle
b. Changing the settings of vacuum sensor (when using all nozzles)
Page 1-26
CM602-L
Reference Manual
+
∗ In this case, all the nozzles to be used must be intended for
CM401/CM402/CM602.
To use CM401/CM402/CM602 nozzles as they are on the
former model, you need to change the settings of vacuum
sensor.
(For the setting procedures, see the following pages,
"Setting procedures of vacuum sensor.")
Former
model-ready
(Orifice change)
Former model-ready
(Orifice detach)
EJM4A-E-RMA01-A01-01