Appendix D: Programming Via The Handheld Programmer; Parameter Menu Structure; The Lcd Display; Using The Handheld Programmer - Siemens Sitrans PROBE LU Instruction Manual

Appendix D: programming via the
handheld programmer
Although the complete range of parameters is only accessible via PDM
and adjust many of the parameters via the Siemens infrared handheld programmer.
• For the complete list of parameters, see
page 73.
Appendix E: LCD menu structure
•
via the handheld programmer, preceded by the menu number.

Parameter Menu Structure

The parameters are organized into function groups, and arranged in a 4-level menu
structure. For example:
1. Identification
1.2. Configuration

The LCD Display

Details on the LCD display are given in

Using the handheld programmer

For Quick Access to parameters via the handheld programmer, press the mode
Note:
key to activate PROGRAM mode, then key in the menu number.
Basic instructions on using the handheld programmer start on page 17, and on doing a
Quick Setup start on page 19.
The following pages give details on how to programme some of the more complex
SITRANS Probe LU parameters via the handheld programmer.
To activate PROGRAM mode, point the handheld programmer at the display (from a
maximum distance of 600 mm [2 ft]), and press the Mode key
page 17).
1.
Remote operation via PROFIBUS PA
Please see
Page 42 SITRANS Probe LU (PROFIBUS PA) – INSTRUCTION MANUAL
on page 49 gives a list of all parameters accessible
1.2.2. Remote Lock.
Startup
Appendix H: Parameter Descriptions
on page 16.
(see illustration on
on page 22.
1
, you can access
on
7ML19985JB02