Table of Contents
Advertisement
Welcome
Congratulations on your purchase of a StationPortal. The StationPortal is an I/O device that
connects factory floor I/O to a server-based system, such as MES and SCADA, over
standard Ethernet. This eliminates the need for a complex and expensive PLC-based
architecture. Operators can use the built-in devices (horn and lamps) as well as plug I/O into
one of the available ports for control by a remote client.
StationPortal is shipped ready for use after a few simple configuration steps. Connect a
power cord that has a standard IEC 60320-C13. Also, connect a standard unshielded,
twisted-pair CAT 5 Ethernet cable between the StationPortal and a Server PC or Ethernet
switch to be able to communicate with your client application. Depending on your
requirements, you may connect and configure input/output devices (see page 12).
Features
Functional Compatibility
Clients: StationPortal is capable of communicating with a variety of clients. If Proficy*
HMI/SCADA CIMPLICITY* software is to be used with StationPortal, version 8.0 or later is
required. The necessary software driver can be ordered on CD as IC647NSD000.
Ethernet cable: Unshielded, twisted pair, UTP CAT 5 minimum
Related Documents
PROFICY HMI/SCADA – CIMPLICITY Communications Manual, StationPortal (This
document is placed in the CIMPLICITY Documentation folder when the driver is installed.
Also available in the StationPortal driver installation file.)
Proficy HMI/SCADA CIMPLICITY software documentation.
Note: The most recent software downloads and user documentation are available on
GFK-2522A
Universal power supply input (100V–240V, 50Hz–60Hz)
Three indicator lights
Status indicators for each digital I/O point
Horn, 90 dB
Serial RS-232 Port
Ethernet port, 10/100 Mbps
Three digital inputs on a 5-pin M12 female connector
Three digital outputs on a 5-pin M12 male connector
Momentary pushbutton
Configuration over Ethernet
Support
website.
Welcome
the
1
Advertisement
Table of Contents
