Troubleshooting; Fault Causes And Rectification - Silvercrest SKR 800 A1 Operating Instructions Manual

Troubleshooting

This section contains important information about fault identification and rectification.
Follow the instructions to avoid hazards and damage.
Fault causes and rectification
The following table will help you to identify and rectify minor malfunctions:
Malfunction
The display
5
indicates nothing.
No sound.
Interference with
the radio recep-
tion.
The time and
station presets are
lost after a power
failure.
NOTE
► If you are unable to resolve the problem by taking any of the aforementioned steps,
please contact the Customer Service department.
SKR 800 A1
Possible cause
The plug is not connected.
The mains power socket is
not supplying power.
The volume is set to minimum.
The device is in clock/
standby mode.
The station is not properly
tuned in.
The reception is weak.
No batteries in the battery
compartment or batteries
12
are dead.
Remedy
Put the power plug into the socket.
Check the house mains fuse.
Increase the volume with the
VOLUME/DISPLAY/
Switch the device on using the
button 3 .
Tune the station correctly using the
button or the button
6
Try to improve reception by realigning
the wire aerial .
13
Press and hold the
about 2 seconds to receive the station
in mono.
Check that the batteries have sufficient
voltage and replace them if necessary.
The time and station presets will need
to be reprogrammed.
GB
dial.
8
.
7
button for
2
15