Table of Contents
Advertisement
Inserting/removing an SD card
When using an SD card for the first time, it is necessary to format the SD card. (l 51) When the SD card is
formatted, all of the recorded data is deleted. Once the data is deleted, it cannot be restored.
Caution:
Check that the access lamp has gone off.
≥ Do not touch the terminals on the back of the SD card.
≥ Do not apply strong shocks, bend, or drop the SD card.
≥ Electrical noise, static electricity or the failure of this unit or the SD card may damage or erase the data stored on the
SD card.
≥ When the card access lamp is lit, do not:
j Remove the SD card
j Turn the unit off
j Insert and remove the USB Cable
j Expose the unit to vibrations or shock
Performing the above while the lamp is on may result in damage to data/SD card or this unit.
≥ Do not expose the terminals of the SD card to water, dirt or dust.
≥ Do not place SD cards in the following areas:
j In direct sunlight
j In very dusty or humid areas
j Near a heater
j Locations susceptible to significant difference in temperature (condensation can occur.)
j Where static electricity or electromagnetic waves occur
≥ To protect SD cards, return them to their cases when you are not using them.
≥ About disposing of or giving away the SD card. (l 29)
42
DVQX1262
Access lamp A
≥ When this unit is accessing the SD card, the
access lamp lights up.
1
Open the SD card slot cover and insert
(remove) the SD card into (from) the card
slot B.
≥ One SD card can be inserted into each of the card slot
1 and the card slot 2.
≥ Face the label side C in the direction shown in the
illustration and press it straight in as far as it will go.
≥ Press the center of the SD card and then pull it straight
out.
2
Securely close the SD card slot cover.
Advertisement
Table of Contents
