Brother ADS-2200 Quick Setup Manual page 4

Product Safety Guide
WARNING
The unit should be connected to an AC power
source within the range indicated on Specifications
in the User's Guide. DO NOT connect it to a DC
power source or inverter. Doing this might cause
an electrical shock or a risk of fire. If you are not
sure what kind of power source you have, contact
a qualified electrician.
This product must be installed near an AC power
outlet that is easily accessible. In case of an
emergency, you must unplug the power cord
from the AC power outlet to shut off the power
completely.
IMPORTANT
• Brother cannot accept any financial or other
responsibilities that may be the result of
your use of this information, including direct,
special or consequential damages. There are
no warranties extended or granted by this
document.
• This machine has been certified to comply
with FCC standards, which are applied to the
USA only.
DO NOT expose the unit to direct sunlight,
excessive heat, open flames, corrosive gasses,
moisture or dust.
DO NOT place the unit on a carpet or rug, as
this will expose it to dust. Exposing the unit to
dust may create a risk of an electrical short or
fire. It may also damage the unit and/or render it
inoperable.
DO NOT place the unit near heaters, air
conditioners, electric fans, refrigerators, radiators,
or water. Doing so may create the risk of a short
circuit or fire should water come into contact with
the unit (including condensation from heating, air
conditioning, and/or ventilation equipment that
may be sufficient to create a short circuit or fire).
4
DO NOT place the unit near chemicals or in a
place where chemicals could be spilled on it.
Should chemicals come into contact with the
unit, there may be a risk of fire or electrical
shock. In particular, organic solvents or liquids
such as benzene, paint thinner, polish remover,
or deodorizer may melt or dissolve the plastic
cover and/or cables, resulting in a risk of fire or
electrical shock. These or other chemicals may
also cause the unit to malfunction or become
discolored.
The product should be placed so as not to
come into contact with any wall or other device.
Otherwise, it could create a risk of overheating
and/or fire. Clearance is needed between the
product and the wall.
CAUTION
Avoid placing the unit in a high-traffic area. If you
must place it in a high-traffic area, ensure that
the unit is in a safe location where it cannot be
accidentally knocked over, which could cause
injury to you or others and serious damage to the
unit.
Ensure that cables and cords leading to the unit
are secured so as not to pose a tripping hazard.
Make sure that no part of the unit protrudes
from the desk or stand where the unit is located.
Make sure that the unit is located on a flat, level,
and stable surface free from vibration. Failure
to observe these precautions could cause the
unit to fall, causing injury to you or to others and
serious damage to the unit.
IMPORTANT
• DO NOT place your machine next to sources
of interference, such as speakers or the base
units of non-Brother cordless telephones.
Doing so may interfere with the operation of
the machine's electronic components.
• DO NOT connect the unit to an AC power outlet
controlled by wall switches or automatic timers.
Disruption of power can delete information from
the machine's memory, and repeated cycling of
the power can damage the unit.