Health And Safety - ABB Navigator 550 Commissioning Instructions

Health & Safety
Safety precautions
Be sure to read, understand and follow the instructions contained within this manual before and during use of the equipment. Failure to do so
could result in bodily harm or damage to the equipment.
Warning. Installation, operation, maintenance and servicing must be performed:

by suitably trained personnel only

in accordance with the information provided in this manual

in accordance with relevant local regulations
Potential safety hazards
Electrical
The Navigator 550 hydrazine wet-section operates from 24 V DC supplied from the Navigator 540 transmitter.
There are no hazardous voltages present.
Chemical reagents
Warning. To ensure safe use when handling chemicals, the following points must be observed:

Review the Material Safety Data Sheets prior to handling containers, reservoirs, and delivery systems that contain chemical
reagents and standards.

Protective eye wear and hand wear must always be used when contact with chemicals is possible.

Normal safety precautions must be taken to avoid the possibility of an accident occurring when operating in conditions of high
pressure and / or temperature.

Chemicals must be stored away from heat, protected from temperature extremes and powders kept dry.

When disposing of chemicals ensure that no two chemicals are mixed.
Safety advice concerning the use of the equipment described in this manual or any relevant Material Safety Data Sheets (where
applicable) can be obtained from the Company, together with servicing and spares information.
Safety standards
This product has been designed to satisfy the requirements of IEC61010-1:2010 3rd edition 'Safety Requirements for Electrical Equipment
for Measurement, Control and Laboratory Use' and complies with US NEC 500, NIST and OSHA.
Safety conventions
Warning. In this manual, a warning is used to indicate a condition which, if not met, could cause serious personal injury and / or death.
Do not proceed beyond a warning until all conditions have been met.
Caution. A caution is used to indicate a condition which, if not met, could cause minor or moderate personal injury and / or damage to
the equipment. Do not proceed beyond a caution until all conditions have been met.
Note. A note is used to indicate important information or instructions that should be considered before operating the equipment.
2 CI/AHM550–EN Rev. D