SETTING
UP THE ANSWERING SYSTEM
While your answering system is set to "Announce only, " the message counter LED on the base displays "A. " If you are using
the prerecorded greeting, the system automatically switches to the following message: "Hello, no one is available to take
your call. Please call again. " If you are using a personal greeting, the system continues to use that greeting. You may need
to change your personal greeting.
Activating the Message Alert
The message alert feature sounds a short alert tone every fifteen seconds after you receive a new message.
To turn on the message alert:
1.
On the handset, press MENU/SELECT. Select the ANSW. SETUP menu, and then the MESSAGE ALERT submenu.
2.
Move the cursor to select ON or OFF .
3.
Press MENU/SELECT. You will hear a confirmation tone.
Activating Call Screening
Your phone allows you to listen to callers leaving you a message. This call screen feature can be turned on or off.
1.
On the handset, press MENU/SELECT. Select the ANSW. SETUP menu and then the CALL SCREEN submenu.
2.
Move the cursor to select ON or OFF .
3.
Press MENU/SELECT. You will hear a confirmation tone.
Setting a Security Code or Personal Identification Number (PIN)
To play your messages from a remote location, you will need to enter a two-digit security code or Personal Identification
Number (PIN). The default security code is 80.
1.
On the handset, press MENU/SELECT. Select the ANSW. SETUP menu, and then the SECURITY CODE submenu.
2.
Use the number keypad (0 through 9) to enter a two-digit security code (01-99).
3.
Press MENU/SELECT. You will hear a confirmation tone.
UC590EH.indd E39
UC590EH.indd E39
E39
8/19/2008 11:39:11 AM
8/19/2008 11:39:11 AM