C Setting The Timer Set - Sanyo DSR-2004 Instruction Manual

RECORD settings
● Setting the MOTION ZONE (P13)
Select the zone where the motion sensor is active. It is
necessary to set a detection frame when PARTIAL ZONE is
selected.
FULL ZONE:
The motion sensor is active on the whole screen.
PARTIAL ZONE:
The motion sensor is active in the set detection frame.
● Setting the MOTION SENSITIVITY
To select MOTION SENSITIVITY and select the level of
detection sensitivity of the motion sensor.
Selections: 1/2/ ... 8/9 (Low sensitivity level)
● Setting the SENSOR TYPE
To select the detection mode when connecting an external
sensor.
To select SENSOR TYPE and select the detection mode.
---: Not operational
N/O: Open type (normal open) when sensor is connected
N/C: Closed type (normal close) when sensor is connected
● Setting the PRE RECORD
To select PRE RECORD and select pre-recording.
ON: Starts recording approximately 5 seconds before the
internal motion sensor or the external sensor detector
is triggered. (Fixed to 1 ips)
OFF: No pre-recording
● Setting the POST EVENT RECORD
To select POST EVENT RECORD and select in how much
time, after the sensor detection, the recording will start.
Selections: 2/3/4 ... 30 SECONDS
● Setting the ALARM
To select ALARM and select the output mode when an
alarm is triggered.
ON: Outputs a signal to an external alarm device when an
internal motion sensor or an external sensor detects.
OFF: Does not output a signal to an external alarm device.
● Setting the ALARM DURATION
To select ALARM DURATION and select the length of the
alarm signal output.
Selections: 1/2/3 ... 58/59/60 SECONDS
● Setting the AUDIO
To select AUDIO and set the audio sound recording.
ON: Records the audio of live videos
To listen to audio sound connect an external
microphone or speaker.
OFF: Does not record the audio of live videos.
C
Setting the TIMER SET
To perform BY SCHEDULE settings.
The recording schedule of each channel can be set using
settings by the hour. (P15)
28