Recording Conditions Set - Sanyo DSR - 300 Instruction Manual

2 MENU-SPECIFIC SETTINGS
(when optional interface board is installed)

5. RECORDING CONDITIONS SET

Set the permission for overwriting to recording areas or the
remaining-space warning level as described below.
1
2
3
4
Setting overwriting permission for the normal
recording area
When the normal recording area has been filled with data,
this setting dictates whether recording will be stopped or
continued by overwriting the recorded images currently
stored on the hard disk.
1
Select "OVERWRITE" for normal
recording area.
[Settings] ( indicates default setting.)
Setting Description
When the normal recording area has been filled with
ON data, overwriting from the beginning of this area will
start automatically.
Recording is stopped when the normal recording area
OFF
has been filled with data.
Setting overwriting permission for the alarm
recording area
When the alarm recording area has been filled with data,
this setting dictates whether recording will be stopped or
continued by overwriting the recorded images currently
stored on the hard disk.
2
Select "OVERWRITE" for alarm
recording area.
[Settings] ( indicates default setting.)
Setting Description
When the alarm recording area has been filled with
ON data, overwriting from the beginning of this area will
start automatically.
Recording is stopped when the alarm recording area
OFF
has been filled with data.
Setting the remaining-space warning level
In situations where the overwrite setting for the normal
recording area and the alarm recording area is "OFF", you
can have the unit issue a warning as soon as the
remaining space in either of these areas reaches a specific
level. ( P. 109)
The following section describes how to set the level at
which the warning will be issued.
3
Setting the remaining-space warning
level.
Setting range: 1% to 10% (in units of 1%)
If the overwrite setting for the normal recording area
and the alarm recording area is "ON", the remaining-
space warning level will be displayed as "**" and setting
will not be possible.
4
Click [SAVE].
The new setting is saved.
102
English