Sanyo DSR - 300 Instruction Manual page 108

2 MENU-SPECIFIC SETTINGS
(when optional interface board is installed)
Setting pre-alarm recording
Set the recording conditions to be used for pre-alarm
recording as described below. ( P. 112)
7
8
7
Select "ON" or "OFF" using "PRE-
ALARM RECORDING".
[Settings]
Setting
ON Performs pre-alarm recording.
OFF Does not perform pre-alarm recording.
When "OFF" has been selected for "ALARM
RECORDING", this item will be displayed as "**" and
selection will not be possible.
8
Make a selection for "REC RATE".
A 10.00/20.00, A 7.50/15.00, A 5.00/10.00, 3.75/7.50,
3.00/6.00, 2.50/5.00, 2.14/4.29, 1.88/3.75, 1.67/3.33,
1.50/3.00, 1.36/2.73, 1.15/2.31, 1.00/2.00, 0.83/1.67,
0.71/1.43, 0.63/1.25, 0.56/1.11, 0.50/1.00 (Unit: FPS)
(Default setting: A 5.00/10.00 FPS)
9
Set the duration for pre-alarm recording
using "DURATION".
2 SEC, 3 SEC, 5 SEC, 10 SEC, 20 SEC, 40 SEC, 1 MIN,
2 MIN, 3 MIN, 4 MIN, 5 MIN, 10 MIN, 15 MIN
(Default setting: 1 MIN)
English
9
Description
Setting alarm triggers
Set the alarm triggers (i.e., launch signals) that constitute
operation conditions for alarm recording as follows.
10
Select a launch signal for alarm
recording using "ALARM TRIGGER".
[Settings] ( indicates default setting.)
Setting
Starts recording when an external alarm is
ALARM
activated.
Starts recording when a motion sensor is acti-
SENSOR
vated.
Starts recording when both an external alarm
ALARM AND
and a motion sensor are activated simulta-
SENSOR
neously.
Starts recording when an external alarm or a
ALARM OR
motion sensor is activated
SENSOR
independent of the other.
External alarm detection
The term "external alarm detection" is used to describe
input of an external detection signal from a door switch
or the like to the unit's alarm input terminal.
Motion sensor detection
The term "motion sensor detection" is used to refer to
detection of motion on the monitor in accordance with
motion sensor settings.
When using a multiplexer, the recorder's motion sensor
is disabled.
107
10
Description