Uses; Preparing Food; Mixing/Chopping - Silvercrest SNM 700 A1 KAT Operating Instructions Manual

WARNING! Risk of material damage!
In order to prevent damage to the de-
vice, interrupt the blending process im-
mediately if the blades of the blade
attachments 8/9 rotate with difficulty or
not at all. In this case, pull out the mains
plug 4 and check whether there is an ob-
struction in the blender jug 5-7.

6.1 Uses

Blade attachment with a cross
blade
8
Use the blade attachment with the cross
blade 8 for mixing whole-fruit beverages
(smoothies) and chopping ice cubes.
Blade attachment with a flat
blade
9
WARNING! Risk of material damage!
Do not use the blade attachment with a
flat blade 9 for liquids!
Use the blade attachment with a flat blade 9
for chopping solid food (e. g. nuts).
NOTE: with an operating time of approx.
10 seconds, use no more than 200 g when
chopping nuts.

6.2 Preparing food

WARNING! Risk of material damage!
Thick or firm peels, (e.g. of citrus fruits,
pineapple), stems and pips of stone
fruits (e.g. cherries, peaches, apricots)
must be removed before blending.
• Rinse or wash the fruits.
• Cut the fruit into rough pieces (approx.
3-4 cm edge length).
• For smoothies: use a sufficient amount
of liquid (mineral water, juice, milk, yo-
ghurt). We recommend a mixing ratio
of 1:1.

6.3 Mixing/Chopping

CAUTION:
Mind the marking MAX for the maxi-
mum filling quantity.
Depending on the hardness and consist-
ency of the ingredients in the blender
jug 5-7, do not fill it to the maximum;
otherwise the blade attachment 8/9
could become clogged.
Due to their exceptional hardness nut-
megs may not be chopped.
NOTE: if the smoothie is too thick, add a lit-
tle mineral water, fruit juice, milk or yoghurt
to suit your taste.
1. Place the fruit pieces and any other in-
gredients into the blender jug 5-7 as
desired. Mind the marking MAX for
the maximum filling quantity.
2. Figure A: screw the required blade at-
tachment 8/9 onto the blender jug 5-7.
Ensure that the blade attachment is tightly
screwed to the blender jug.
3. Figure B: turn the blender jug 5-7
around and place it on the base unit 1.
The small noses 13 on the edge of the
blender jug fit into the recesses at the
head of the base unit 1.
4. Connect the mains plug 4 with the wall
socket.
5. A slight clockwise turn of the blender
jug 5-7 switches the device on.
Let the device run for no more than
60 seconds.
6. A slight anticlockwise turn of the blend-
er jug 5-7 switches the device off.
Wait until the blade 8/9 has come to a
standstill.
19
GB