Table of Contents
Advertisement
4.8
Removing and installing the protection cover
The protection cover of the hollow shaft is delivered ready-fitted to the gearbox flange.
Dismantle the protection cover for installation of the output shaft.
①
②
Figure 4-3
Procedure
1. Unscrew the bolts
gasket
2. Fit the output shaft.
3. Use a suitable cleaning agent to clean the contact surface of the protection cover
the gearbox.
4. Ensure that the flat seal
5. Wet the bolts
6. Screw on the protection cover
7. Protect all remaining bare areas with a suitable permanent anti-corrosive agent.
You have now installed the protection cover for operation.
BA 2030
Operating Instructions, 11/2017, A5E37880173A/RS-AE
ATEX version gearboxes
Sparks may be caused by a damaged protection cover. Replace damaged
protection covers immediately.
①
Secure bolts
with, e.g. Loctite 243 medium-strength adhesive.
Bolt
Protection cover
Protection cover for hollow shaft
①
and remove the protection cover
③
.
③
①
with medium-strength adhesive, e.g. Loctite 243.
4.8 Removing and installing the protection cover
③
Flat seal
④
Gearbox housing
is correctly seated.
②
.
②
together with the flat
Installation
②
on
33
Advertisement
Table of Contents
