Table of Contents
Advertisement
Service and maintenance
8.1 General notes about maintenance work
Remedy
First oil change after
commissioning.
Subsequent oil changes.
Visual inspection of the
gearbox and shaft sealing ring
for leaks.
When required, replace the
breather valve.
Clean the gearbox.
Carry out a complete inspection
of the geared motor.
Check the friction clutch and
adjust if necessary.
Check the coupling.
Check that fastening bolts on
gearboxes and add-on elements
are securely tightened. Check
that covers and plugs are
securely fastened.
Change the roller bearing
grease.
Replace the bearing.
Check the rubber buffer of the
torque arms.
Check the hose of the oil
expansion unit.
Lubricate the XLplus and VLplus
heavy-duty bearing systems.
When using synthetic oils, the intervals can be doubled. The data specified is valid for an oil
1)
temperature of +80° C. See the figure titled "Guide values for oil change intervals" for the intervals
for other temperatures.
66
Interval
After approximately
10,000 operating hours or at the
latest after 2 years.
Every 2 years or
10,000 operating hours
.
1)
After the first day, thereafter
monthly.
Once a year.
Depending on degree of soiling,
at least every 6 months.
Every 12 months.
After 500 hours, thereafter once
a year and after every blockage.
For the first time after 3 months. Please refer to the separate
After 3 hours, and then every 2
years.
When the oil is changed.
-
Every 6 months.
Check regularly; renew every 4
years at the latest.
-
Operating Instructions, 11/2017, A5E37880173A/RS-AE
Description of work
Checking and changing
lubricants (Page 67)
Checking the gearbox for leaks
(Page 83)
Replacing the vent valve
(Page 84)
Cleaning the gearbox (Page 84)
Inspecting the gearbox
(Page 85)
Observe the BA 2039 Operating
Instructions.
operating instructions.
Checking tightness of fastening
bolts (Page 85)
Change the roller bearing
grease (Page 76)
Replace bearings (Page 82)
Torque arms with shaft-mounted
gearboxes (Page 48)
Replacing the hose of the oil
expansion unit (Page 86)
Lubrication of the XLplus and
VLplus heavy-duty bearing
systems (Page 80)
BA 2030
Advertisement
Table of Contents
