Using The Headphones - Silvercrest SBKO 4.0 D1 Operating And Safety Instructions Manual

this, follow the user manual of your smartphone or
media player. Select the SBKO 4.0 D1 device from
the list of discovered devices and make the
connection. If you are asked for a PIN, enter
"0000".
Once the connection is made, the LED (7) flashes blue
once briefly about every 10 seconds. As soon as your
music player is powered off or is out of range, the
headphones go into Standby mode (not connected)
and the LED (7) flashes orange once briefly every 3
seconds.
If you want to connect a different device (smartphone
or media player) to the headphones, you must repeat
the pairing process as described previously.
As soon as the previously connected device comes into
range of the
automatically made. In some cases, you have to
confirm the connection on your device.

Using the headphones

To wear the headphones correctly, pay attention to the
writing on the inside of the ear buds (1): R = right, L =
left. The buttons and the LED (7) are on the right side.
Carefully push one of the ear buds (1) into your ear
canal. While doing this, rotate the ear bud (1) into your
ear. To simplify this, you can straighten the ear canal
somewhat by pulling your ear slightly backward and
upward. Proceed with the second ear bud (1) in the
same way.
SilverCrest SBKO 4.0 D1
headphones, the connection is
- 21