Mitsubishi Electric MELSEC iQ-R Series User Manual page 45

*1 The LED display scrolls horizontally (right to left) to display the portion not appeared on dot matrix LED.
*2 The selected operation is registered in the behavior caused when holding the switch in the SELECT position, and can be performed
even in the normal operation mode.
*3 The character string output with the C Controller module dedicated function (CCPU_SetDotMatrixLED) is displayed. In addition, when
this operation is selected again after switched to other operation, the previously shown character string will be displayed.
*4 The latest error is displayed. ("" is displayed when no error occurred.)
*5 When an IP address is not set, "..." is displayed.
■Performing the 'notification/unmount' in the normal operation mode
The last selected operation (out of 'notification/unmount') in the operation selection mode is registered as the operation
performable by holding the switch in the SELECT position. By holding the MODE/SELECT switch in the SELECT position, the
registered operation can be performed even in the normal operation mode.
• By setting the MODE/SELECT switch to the SELECT position once during the normal operation, the
operation that is currently selected is displayed on the dot matrix LED display.
• Even while performing the operation among the 'information display on the dot matrix LED', the operation
among the 'notification/unmount' can also be performed.
(1)
1.
Hold the MODE/SELECT switch (1) in the SELECT position.
2.
The operation selected in the operation selection mode is
performed.
6 PROCEDURE BEFORE OPERATION
43
6.5 Switch Operation
6