General Control - Sharp DX-AT50 Operation Manual

General control

" Connecting the AC power cord
Subwoofer/amplifier unit
After checking all the connections, connect the AC power cord to the AC power input
jack, then the subwoofer/amplifier unit into the AC outlet.
(AC INPUT)
DVD Player
After checking all the connections, plug the DVD player into the AC outlet.
Notes:
! The power is supplied to the AV control unit by the subwoofer/amplifier unit. The
AV control unit is not equipped with a power cord.
! Never use a power cord other than the one supplied. Otherwise, a malfunction or
an accident may occur.
! Unplug the DVD player and the subwoofer/amplifier unit if they will not be used for
a prolonged period of time.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT, FULLY INSERT.
" To turn the power on
Press the ON/STAND-BY button.
The power indicator lights up.
If the power does not turn on, check if the power cord is plugged in properly.
Note:
When the ON/STAND-BY button on the remote control is pressed, the power on both
units turns on.
" Volume control
Press the VOLUME + button to increase the volume and the VOLUME - button for
decreasing.
AC outlet
(AC 120 V, 60 Hz)
" To change the display brightness (2 levels)
You can switch the display brightness by holding down the DISPLAY button on the
Prise murale
remote control for 2 seconds or more.
(120 V CA, 60Hz)
Caution:
The display brightness depends on the setting of "PANEL DISPLAY" of "Changing
the initial setting of DVD". (See page 20.)
.....
0 1 2 39 40
Dimmed Brightened
Power indicator
SD-AT50
DX-AT50
ENGLISH
[Front]
E-18