Changing The Registration In The Remote Control - Sharp DX-AT50 Operation Manual

Changing the registration in the remote control

Sharp's TVs can be operated with the remote control of this system without register-
ing the operation (except for some models). (See page 47.) You can also operate
TVs of other manufacturers by changing the registration in the remote control.
[Front] [Back]
" Changing the TV registration
Use buttons on both sides of the remote control.
1
While holding down the TV ON/STAND-BY button, press the TV
CHANNEL button.
2
Enter the manufacturer setting number (2 digits) with the direct
buttons (0 - 9) and press the TV ON/STAND-BY button.
The setting is registered and the TV can be operated with the remote control of
this system.
TV manufacturer Setting number
SHARP 01(*), 02
PANASONIC 03, 04, 05
JVC 06, 07, 08
SONY 09
MITSUBISHI 10, 11, 12, 13
HITACHI 14, 15, 16, 17
TOSHIBA 18, 19
PIONEER 20
SANYO 21, 22, 23, 24
FUJITSU 25
AIWA 26
FUNAI 27, 28, 29, 30, 31,
32
SAMSUNG 33, 34, 35, 36
(*): The default manufacturer number is 01 (SHARP).
Notes:
! As for manufacturers with 2 or more setting numbers, select one of those numbers
with which you can operate the TV.
! The number will not be set unless the registration is completed within 30 seconds.
In that case, try registration again.
! Once you set a number, the number previously memorized will be canceled.
! After replacing the batteries in the remote control, the registered number may
automatically be set to 01 (SHARP). If it occurs, register the desired number
again.
! Registration cannot be executed depending on TVs. Even if numbers can be set,
some buttons may not work.
TV manufacturer Setting number
EMERSON 37, 38, 39, 40
FISHER 23
GE 41, 42
GOLDSTAR 43
MAGNAVOX 44, 45
RCA 46, 47, 48, 49
ZENITH 50, 51
PHILIPS 52, 53
THOMSON 54
GRUNDIG 55
FERGUSON 56, 57
ITT NOKIA 58, 59
LOEWE 60, 61
SD-AT50
DX-AT50
ENGLISH
E-40