Setting The Station Id; Setting The Broadcasting System - Sony BVP-900 Series System Manual

3-2-6 Setting the Station ID

When a CNU-700 with a BKP-7933 installed is
connected to the routing switcher system via the S-
BUS, the station ID of the CNU-700 should be set.
Notes
• Do not assign duplicate station IDs in an S-bus data
link.
• The S-BUS ID No. switch should be set upon BKP-
7933 installation. Never change the setting after
installation. Otherwise the S-BUS may not function
correctly.
S-BUS ID No.
1 ( ON )
0 ( OFF )
1 2 3 4 5 6 7 8
( 1 2 4 8 16 32 64 128 )
Setting example
Station ID 3: 1 1 0 0
64: 0 0 0 0
0 0 0 0
0 0 1 0
3-2-7 Setting the Broadcasting
System
If a reference signal is input to the REFERENCE
connector on the CNU-700 when the power of the
CNU-700 is turned ON, the broadcasting system
(NTSC or PAL) is automatically set to that of the
reference signal. If no reference signal is input, select
the system with the S3-1 switch on the component side
of the AT board as follows:
For the 525-line system: OFF
For the 625-line system: ON
At the factory, the switch for the NTSC model is set to
OFF and that for the PAL model is set to ON.
SYNC ON/OFF
S3
D4 S4 S5 S6
AT board of the CNU-700
ON
S7
OFF
S3 switch
RV1
3-59
Chapter 3 Initial Settings