Wireless Temperature Sensor; Preparing And Maintaining The Wireless Temperature; Sensor; Connecting The Wireless Temperature Sensor To The Control Panel - Siemens EZ9**KZ series Instruction Manual

‚Wireless temperature

sensor

W i r e l e s s t e m p e r a t u r e s e n s o r
Connect the wireless cooking sensor to the control
panel before using the cooking sensor functions for the
first time.
Preparing and maintaining the wireless
temperature sensor
This section provides information on:
Attaching the silicone patch
■
Attaching the wireless cooking sensor
■
Cleaning
■
Replacing the battery
■
The silicone patch and temperature sensor can be
purchased from specialist retailers or through our
technical after-sales service or our official website. To
do this, quote the relevant reference number:
00577921 Set of 5 silicone patches
HZ39050 Temperature sensor and set of 5 silicone patches
Adhering the silicone patch
The silicone patch attaches the wireless cooking sensor
to the cookware.
If you are using an item of cookware with cooking
sensor functions for the first time, attach the silicone
patch directly to it. Proceed as follows:
That the adhesive area on the pan is free from
1.
grease. Clean the pan, dry it thoroughly and wipe the
adhesive area with a spirit.
Remove the protective film from the silicone patch.
2.
Adhere the silicone patch to the outside of the pan in
the correct place using the enclosed template as a
guide.
Press down all over the surface of the silicone patch,
3.
including in the centre.
The adhesive requires one hour to fully harden. Do not
use or clean the pan during this time.
Notes
Do not leave the pan with the silicone patch to soak
■
soapy water for long periods of time.
If the silicone patch comes off, attach a new one.
■

Wireless temperature sensor

Fitting the wireless temperature sensor
Attach the temperature sensor to the silicone patch and
align it correctly.
Notes
Ensure that the silicone patch is completely dry
■
before attaching the cooking sensor.
Fill the pot so that the contents reach high enough to
■
cover the cooking sensor's silicone patch.
To prevent overheating, do not attach the cooking
■
sensor to other hot cookware.
Remove the cooking sensor from the pot after
■
cooking. Store it in a clean, safe place away from
sources of heat.
You can use up to three cooking sensors at the
■
same time.
Connecting the wireless temperature sensor
to the control panel
To connect the wireless temperature sensor to the
control panel, follow the instructions below:
Open the docking menu.
1.
Open the basic settings and select "Cooking sensor"
2.
from the menu.
Select the Add a new cooking sensor option.
3.
Press the symbol on the wireless temperature
»
sensor within 30 seconds.
After a few seconds, the status of the connection
between the temperature sensor and the control
panel will appear on the display.
The cooking sensor functions are made available once
the wireless cooking sensor has been connected to the
control panel correctly.
Notes
A faulty connection due to the wireless cooking
■
sensor not being detected may be caused by the
following:
– Bluetooth communication error.
– You did not press the symbol on the wireless
cooking sensor within 30 seconds.
– The battery in the wireless cooking sensor is
almost flat.
Reset the wireless cooking sensor and repeat the
connection procedure.
If there are problems with the connection due to a
■
transmission error, repeat the connection procedure.
If you continue to experience connection problems,
contact our technical after-sales services.
en
23