Cleaning; Changing The Battery - Siemens EZ9**KZ series Instruction Manual

Wireless temperature sensor
en
Resetting the wireless temperature sensor
Touch the symbol on the cooking sensor for
»
1.
approximately 8-10 seconds.
While you are doing this, the temperature sensor's
LED indicator will light up three times. When the LED
lights up for the third time, it will start to reset the
temperature sensor. Stop touching the symbol when
this happens.
Once the LED goes out, this means that the wireless
temperature sensor has been reset.
Repeat the connection procedure.
2.

Cleaning

Do not clean the wireless temperature sensor in the
dishwasher.
Temperature sensor
Clean the temperature sensor with a damp cloth. Never
clean it in the dishwasher. Do not immerse it in water or
clean it under running water.
Remove the temperature sensor from the saucepan
after cooking. Store it in a clean, safe place (such as in
its packaging) away from sources of heat.
Silicone patch
Clean and dry before attaching to the temperature
sensor. Dishwasher safe.
Note:
Cookware with the silicone patch must not be left to
soak for long periods in soapy water.
Temperature sensor window
The sensor window must always be clean and dry.
Proceed as follows:
Remove dirt and oil splatters regularly.
■
Use a soft cloth or cotton buds and window cleaner
■
for cleaning.
Notes
Do not use abrasive cleaning agents such as
■
scouring pads, scrubbing brushes or cream
cleaners.
Do not touch the sensor window with your fingers.
■
This may make it dirty or scratch it.
24

Changing the battery

C h a n g i n g t h e b a t t e r y
If the temperature sensor does not light up when the
symbol is pressed, the battery is flat.
Changing the battery:
Remove the silicone cover from the lower section of
1.
the temperature sensor housing and remove both
screws using a screwdriver.
Open the closure of the temperature sensor.
2.
Remove the battery from the lower section of the
housing and insert a new battery (pay attention to
the correct orientation of the battery poles).
Caution!
Do not use any metal objects to remove the battery.
Do not touch the battery connection points.