Sharp CD G14000 Operation Manual page 12

System connections (continued)
CD-G14000
Antenna connection
Supplied FM antenna:
Connect the FM antenna wire to the
FM 75 OHMS jack and position the FM
antenna wire in the direction where the
strongest signal can be received.
Supplied AM loop antenna:
Connect the AM loop antenna to the
AM and GND terminals. Position the
AM loop antenna
reception. Place the AM loop antenna
on a shelf, etc., or attach it to a stand
or a wall with screws (not supplied).
Note:
Placing the antenna on the unit or near the AC power cord may
cause noise pickup. Place the antenna away from the unit for better
reception.
Installing the AM loop antenna:
< Assembling >
12
FM
antenna
for optimum
ANTENNA
FM
75 OHMS
< Attaching to the wall >
Wall Screws (not supplied)
Speaker connection
Front speakers:
Connect the black wire to the FRONT SPEAKERS (–) terminal, and
the red wire to the FRONT SPEAKERS (+) terminal.
AM loop
antenna
Front speaker (right)
GND AM
Front speaker (right)
Caution:
Connect the speaker wires to the speakers first, then to the unit.
If you use other speakers with impedance lower
than that specified, the unit may be damaged.
Front speakers: 6 ohms
Do not mistake the right and the left channels. The
right speaker is the one on the right side when you
face the unit.
Do not let the bare speaker wires touch each other.
Do not allow any objects to fall into or to be placed
in the bass reflex ducts.
Do not stand or sit on the speakers. You may be
injured.
Front speaker (left)
Front speaker (left)
Red
Black
Incorrect
Incorrect